Study Assistive Devices Fit And Safe Use in Nclexrn with focused flashcards that help you recognize the idea, recall the key rule, and apply it in practice-style prompts.
All flashcards
Flashcard 1: What is the correct crutch length fit using body landmarks while the patient is standing?
Answer: Tip 6 in lateral/6 in anterior; pad 2 to 3 fingerbreadths below axilla. These measurements ensure proper height for support while avoiding axillary pressure and maintaining balance.
Flashcard 2: Which instruction best describes safe cane placement during ambulation?
Answer: Place cane about 6 inches lateral and 6 inches anterior. This positioning creates a wide base of support to enhance balance and prevent falls.
Flashcard 3: What elbow flexion angle indicates proper cane fit when the hand rests on the cane handle?
Answer: About 20∘ to 30∘ elbow flexion. This angle allows comfortable weight distribution and prevents strain on the elbow or shoulder during use.
Flashcard 4: What is the correct sequence to stand up from a chair when using crutches?
Answer: Both crutches in one hand; push up from chair; then position crutches. This technique ensures safe weight transfer from the chair before properly positioning the crutches.
Flashcard 5: What is the correct cane length landmark when a patient stands upright with arms relaxed?
Answer: Handle at the level of the greater trochanter. This landmark ensures the cane provides optimal support without causing shoulder elevation or poor posture.
Flashcard 6: When going down stairs with a cane, which moves first?
Answer: Cane + weak leg first, then strong leg. Advancing the supported weak leg first controls descent and reduces risk of falling forward.
Flashcard 7: Which footwear choice best supports safe use of assistive devices during ambulation?
Answer: Low-heeled, well-fitting shoes with non-skid soles. Such footwear enhances traction, stability, and balance to minimize slip risks with devices.
Flashcard 8: What is the correct sequence to sit in a chair when using crutches?
Answer: Back to chair; both crutches in one hand; grasp chair; sit. This method maintains balance by using the chair for support while freeing a hand for stability.
Flashcard 9: Which crutch gait is used for a patient with partial weight-bearing on one leg?
Answer: Three-point gait. This gait advances both crutches with the affected leg, allowing partial weight on the injured side.
Flashcard 10: Which instruction best prevents falls when using a walker?
Answer: Do not pull on the walker to stand; push from the chair/bed. Pushing from a stable surface maintains walker stability and prevents backward tipping during standing.
Flashcard 11: What is the correct stair rule for crutches?
Answer: Up with the good, down with the bad. This rule prioritizes the unaffected leg for ascending stability and supported descent for safety.
Flashcard 12: Which crutch gait is appropriate for bilateral lower-extremity weakness but some weight-bearing?
Answer: Four-point gait. This alternating gait provides maximum stability for patients able to bear some weight on both legs.
Flashcard 13: What elbow flexion angle indicates proper handgrip height for crutches?
Answer: About 20∘ to 30∘ elbow flexion. This flexion promotes ergonomic positioning for weight-bearing through the hands without excessive bending.
Flashcard 14: Identify the most important pre-use safety check for any cane, crutch, or walker tip.
Answer: Rubber tip must be intact, clean, and non-skid. Intact tips provide essential traction to prevent slipping and ensure safe weight-bearing support.
Flashcard 15: What is the proper walker height landmark when the patient stands inside the walker?
Answer: Handgrips at the level of the wrist crease (ulnar styloid). This alignment allows natural arm positioning for effective support and comfortable grip height.
Flashcard 16: What is the correct rule for stairs when using a cane?
Answer: Up with the good, down with the bad. This mnemonic ensures the stronger leg leads upward for stability and the device supports descent.
Flashcard 17: When going up stairs with a cane, which limb moves first?
Answer: Strong leg first, then cane + weak leg. Leading with the strong leg provides propulsion and stability before advancing the supported weak leg.
Flashcard 18: Which side should hold the cane when one leg is weak or painful?
Answer: Hold the cane on the strong (unaffected) side. Holding on the unaffected side maximizes stability and weight transfer to support the weak leg.
Flashcard 19: Which action is safest when a patient becomes dizzy while ambulating with an assistive device?
Answer: Stop, sit if possible, and assess before continuing. Pausing allows symptom resolution and evaluation to prevent falls or further complications.
Flashcard 20: Which crutch gait is fastest and requires good balance and strength?
Answer: Two-point gait. This gait simulates normal walking with simultaneous crutch and opposite leg movement for speed.
Flashcard 21: What is the correct basic sequence for walking with a standard walker?
Answer: Walker forward, then weak leg, then strong leg. This pattern ensures stability by advancing the device first, followed by controlled leg movements.
Flashcard 22: What is the key safety rule that prevents neurovascular injury with axillary crutches?
Answer: Support weight on hands, not in the axilla. Bearing weight on the hands prevents compression of axillary nerves and vessels, avoiding injury.
Flashcard 23: What elbow flexion angle indicates proper walker fit when holding the grips?
Answer: About 20∘ to 30∘ elbow flexion. This angle facilitates proper posture and weight distribution without straining the upper body.
Flashcard 24: What is the correct gait sequence for using a cane with one weak leg on level ground?
Answer: Cane + weak leg together, then strong leg. This sequence mimics natural gait while providing support to the weak leg during advancement.